Nuts about the SN and SNSW
Prefabrication offers countless benefits to installers, and many of these advantages are passed on to everyone involved with the project. When installers use prefabrication, it also helps building owners in the following ways:
Prefabrication can undeniably reduce the amount of time required for installation. However, prefab offers additional ways to make a contractor’s job easier. By moving most work off-site, several timely tasks become unnecessary:
Prefabrication can greatly reduce the amount of time needed to complete a variety of job site tasks. In particular, it can make an installer's job much easier.
Read on to learn about prefabrication's top three benefits to installers.
One of the biggest health risks to installers who frequently work with concrete is exposure to crystalline silica dust. Crystalline silica is found in many naturally-occurring minerals and is common in concrete. Although harmless in a set slab, when the set concrete is drilled or cut, the dust flies into the air and can be easily breathed in by a contractor who is not taking proper precautions. An estimated 2 million workers are at risk of negative health effects in the United States alone.
USING CADDY ROD LOCK COUPLERS ON INSULATED STRUCTURES:
Threaded rod couplers are used to connect two male ends of threaded rod to each other. Although they can be used simply to extend the length of a threaded rod, couplers provide the most value to installers when used on insulated structures.
421 CLEVIS HANGER:
The 421 clevis hanger improves installation whether using black, plastic, or insulated pipe. However, contractors see the most value when the 421 is coupled with the 121 insulation shield for insulated pipe.
DROP-IN LOOP HANGER:
Traditionally, loop hangers have been commodity products that are mostly similar across manufacturers. Although they are low in material cost and sufficient at holding pipe, they can be very costly because of the long, tedious installation process. Most contractors typically install pipe by sliding each section through the hanger individually and then adding turns, sprinkler heads, and branch lines later. The whole process is timely and involves hours of dangerous overhead work.
The CADDY Drop-in Loop Hanger makes installation much simpler and quicker. Because the pipe assemblies do not need to slide through the hanger, large assemblies can be prefabricated on the ground and installed in one piece.